Clean and Dry Wet Buildings Quickly, Safely

Ken Hellevang, a North Dakota State University Extension engineer, has these tips to help the cleanup go more smoothly and safely:

• Stay safe. When using wet/dry vacuums and other cleaning equipment, use an extension cord with a ground fault circuit interrupter or install a ground fault circuit interrupter in electrical circuits. Do not stand in water when using electrical equipment.
• Wear boots, gloves and other protective gear. Overland flooding also may contain some biological or chemical contamination, and sewer backup contains extensive biological contamination. Porous materials such as carpet or drywall that can absorb water need to be discarded if they were exposed to sewer backup or other water with biological or chemical contamination.
• Wet materials will mold in one to three days, depending on temperature, so cleanup and drying need to be done quickly. Mold in buildings is a human health hazard. Exposure to mold spores can trigger asthma in sensitive people, and allergy symptoms in many people. The symptoms include sneezing, nasal congestion, runny nose and itchy watery eyes. Mold must be removed, not just killed by using a biocide such as chlorine bleach, to eliminate the hazard. Open at least two windows for cross-ventilation to remove moisture in the house or use a dehumidifier. Adding heat without exhausting the air just creates a warm, humid environment and does not aid drying. Use fans to circulate air across damp surfaces to help the material dry.
• Clean and dry carpets and rugs quickly. For health reasons, discard carpet if it was exposed to sewage or if mold growth occurred. It is best to use hot water extraction to clean soiled carpets, so either have them professionally cleaned or rent the equipment to do it yourself. To clean small carpets or rugs, move them outside and hose them down. Use a disinfecting carpet cleaner to clean them thoroughly. Dry the carpet or rugs and floor rapidly and thoroughly before replacing the carpet. Replace the padding; do not try to dry it. Use a moisture meter to assure that a wood floor is dry before replacing the carpet or rugs. Before placing carpet on concrete, tape a 3-foot-square plastic sheet on the concrete for a couple of days to make sure moisture vapor is not coming through the floor to create damp conditions conducive for mold growth.
• If the carpet can't be removed, dry it within 48 hours of when it became wet, using a wet/dry vacuum, dry outdoor air and/or dehumidifier to minimize mold growth. Use fans to circulate air above and underneath the carpet. Unless the carpet is very thin and does not have a pad, such as an indoor/outdoor carpet, lifting it to expose both sides for drying is very important. Mold growth likely will occur unless the carpet can be dried within 24 to 48 hours, depending on temperature.
• Clean and disinfect nonporous materials. Scrub surfaces with hot water and a heavy-duty cleaner. Then disinfect the materials for biological contamination with a solution of 1/4 cup of chlorine bleach per gallon of water or a product that is labeled as a disinfectant to kill germs. Follow label directions. Don’t mix cleaning products because a combination of chemicals can give off toxic fumes.

Source: ndsu.edu

Photo Credit: GettyImages-FrankvandenBergh